ASVAB Electronics Information Practice Test 421800 Results

Your Results Global Average
Questions 5 5
Correct 0 3.29
Score 0% 66%

Review

1

Which of the following is not a characteristic of direct current?

47% Answer Correctly

used to power your cell phone

cannot easily travel distances without power loss

electrons flow in only one consistent direction

an example power source is a generator


Solution

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of DC is a battery. In contrast to the constant one-way flow of direct current, alternating current changes direction many times each second. Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances.


2

The volt is a unit of measurement for:

79% Answer Correctly

capacitance

voltage

power

current


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.


3

Resistance and current are __________ proportional.

68% Answer Correctly

exponentially

inversely

directly

not


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


4

Why is an insulator a poor conductor of electricity?

68% Answer Correctly

an insulator is made of organic material

an insulator has many free electrons

an insulator has few free electrons

an insulator is made of inorganic material


Solution

Insulators have valence shells that are more than half full of electrons and, as such, are tightly bound to the nucleus and difficult to move from one atom to another.


5 How would you connect 6 [12V 20A] batteries to achieve a combined power output of 36V 60A?
66% Answer Correctly
series
orthogonal
parallel
series-parallel

Solution

Connecting the 6 batteries in series multiplies their voltage while keeping their current the same yielding a 72V 20A configuration. Connecting the 6 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 12V 120A configuration. Using a series-parallel connection, 3 batteries can be connected in series and 3 can be connected in parallel resulting in a 36V 60A configuration.