ASVAB Electronics Information Practice Test 426492 Results

Your Results Global Average
Questions 5 5
Correct 0 3.17
Score 0% 63%

Review

1

This circuit component symbol represents a(n):

67% Answer Correctly

diode

inductor

transistor

transformer


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


2

Which of the following is not a characteristic of direct current?

47% Answer Correctly

used to power your cell phone

an example power source is a generator

cannot easily travel distances without power loss

electrons flow in only one consistent direction


Solution

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of DC is a battery. In contrast to the constant one-way flow of direct current, alternating current changes direction many times each second. Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances.


3 Use Ohm's Law to calculate the value of resistance in this circuit if voltage is 105 volts and current is 3.5 amps.
80% Answer Correctly
10 Ω
30 Ω
37 Ω
27 Ω

Solution

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.

Solved for resistance, R = \( \frac{V}{I} \) = \( \frac{105}{3.5} \) = 30 Ω


4

Silver and gold are among the most highly conductive elements. Why is copper used much more often as a conductor in electrical circuits?

80% Answer Correctly

silver and gold are brittle

silver and gold are costly

copper is durable and relatively cheap

all of these


Solution

All conductors have resistance and the amount of resistance varies with the element.  But, resistance isn't the only consideration when choosing a conductor as the most highly conductive elements like silver and gold are also more expensive and more brittle than slightly less conductive elements like copper. A balance needs to be struck between the electrical qualities of a material and its cost and durability.


5

Which of the following is not true about a line drop?

43% Answer Correctly

it is caused by resistance

it is a decrease in voltage between two points on a line

it is addressed by raising voltage and lowering current across the transmission line

it is addressed by raising current and lowering voltage across the ransmission line


Solution

Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances. A line drop is a decrease in voltage between two points on an electrical transmission line due to resistance in the line. A lower current and higher voltage across the line will help compensate for the line drop.