Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery.

Capacitors store voltage and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.

The purpose of a capacitor is to retain electric charge and it will do so even after its input voltage is removed. After the input voltage is removed, the capacitor will slowly discharge but, depending on the size and characteristics of the capacitor, discharging could take from a few minutes to a few years. So, it's never safe to touch a capacitor with your hands and you should make sure to discharge any capacitors in a circuit before working on it using an appropriately high-wattage resistor or a capacitor discharge tool.

In a parallel circuit, each load occupies a separate parallel path in the circuit and the input voltage is fully applied to each path. Unlike a series circuit where current (I) is the same at all points in the circuit, in a parallel circuit, voltage (V) is the same across each parallel branch of the circuit but current differs in each branch depending on the load (resistance) present.

Semiconductors have valence shells that are exacly half full and can conduct electricity under some conditions but not others. This property makes them useful for the control of electrical current.