ASVAB Electronics Information Practice Test 433688 Results

Your Results Global Average
Questions 5 5
Correct 0 3.16
Score 0% 63%

Review

1

Inductance is a factor in which of the following?

44% Answer Correctly

a DC circuit

batteries connected in serial

determining energy stored by a capacitor

an AC circuit


Solution

Inductance is a property of an AC circuit (or a component in an AC circuit) that quantifies resistance to changes in current. The current in an AC circuit is continuously changing and inductive reactance (the opposition to change) depends both on the inductance of the circuit or component and the rate at which the current is changing.


2 How would you connect 8 [15V 20A] batteries to achieve a combined power output of 120V 20A?
53% Answer Correctly
parallel
orthogonal
series
series-parallel

Solution

Connecting the 8 batteries in series multiplies their voltage while keeping their current the same yielding a 120V 20A configuration. Connecting the 8 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 15V 160A configuration. Using a series-parallel connection, 4 batteries can be connected in series and 4 can be connected in parallel resulting in a 60V 80A configuration.


3

A capacitor to an electronic circuit is like a _______________ to a house?

66% Answer Correctly

storage shed

gate

safe

driveway


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


4

Capacitors store:

69% Answer Correctly

resistance

current

electricity

capacitance


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


5 A circuit with a 120-volt power supply is protected by a 10-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
82% Answer Correctly
400 W
1201.5 W
1202 W
1200 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 10A circuit breaker would allow is 120V x 10A = 1200 W.