A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.

Splicing is permanently joining two wires together. Splicing can be done with screw-on connectors or wire crimps but the preferred method for splicing is soldering. Soldering takes the most effort but results in a connection that is electrically and mechanically identical to the original wire.

Resistors can be chosen in a wide variety of values to control the voltage in a circuit, limit the current, or moderate the heat produced by the components in the circuit.

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.

Resistance is opposition to the flow of current. As resistance increases, current decreases as resistance and current are inversely proportional.