ASVAB Electronics Information Practice Test 458059 Results

Your Results Global Average
Questions 5 5
Correct 0 3.44
Score 0% 69%

Review

1

Which of the following is a difference between a circuit breaker and a fuse?

80% Answer Correctly

a circuit breaker can be reused

a fuse is cheaper than a circuit breaker

a fuse responds more quickly than a circuit breaker

all of these


Solution

Like fuses, circuit breakers stop current flow once it reaches a certain amount. They have the advantage of being reusable (fuses must be replaced when "blown") but respond more slowly to current surges and are more expensive than fuses.


2

In a series circuit, which of the following is the same across all branches of the circuit?

60% Answer Correctly

current

resistance

voltage

conductance


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.


3

Which of the following will help to prevent a short circuit?

74% Answer Correctly

transistor

fuse

diode

resistor


Solution

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.


4

The rate of flow of electrons per unit time is which of the following?

74% Answer Correctly

voltage

current

conductance

resistance


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). A coulomb (C) is the quantity of electricity conveyed in one second by a current of one ampere.


5

Which of the following is the preferred method for splicing wires?

56% Answer Correctly

soldering

wire crimps

wrap in small gauge wire

screw-on connectors


Solution

Splicing is permanently joining two wires together. Splicing can be done with screw-on connectors or wire crimps but the preferred method for splicing is soldering. Soldering takes the most effort but results in a connection that is electrically and mechanically identical to the original wire.