ASVAB Electronics Information Practice Test 466098 Results

Your Results Global Average
Questions 5 5
Correct 0 3.11
Score 0% 62%

Review

1

In household electrical wiring, which color of insulation indicates the 'hot' wire?

50% Answer Correctly

black

red

green

white


Solution

In the NM cable used for wiring homes, each cable has three wires inside a sheath with each wire covered in a different color of insulation to indicate its type. The wire with the black insulation is the 'hot' wire, white is the neutral wire, and the ground wire is either covered in green insulation or left bare.


2

A transistor works by allowing a small amount of current to control general current flow. Where is the small amount of current applied?

55% Answer Correctly

collector

input

base

emitter


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


3

Which of the following allows encapsulating complex circuit designs for easier integration into electronic devices and machines?

67% Answer Correctly

parallel circuits

series circuits

series-parallel circuits

integrated circuits


Solution

Circuits containing transistors are packaged into integrated circuit chips that allow encapsulating complex circuit designs (CPU, memory, I/O) for easier integration into electronic devices and machines.


4

Resistance is opposition to which of the following?

70% Answer Correctly

current

conductance

impedance

voltage


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


5

A capacitor is often used for which of the following purposes?

68% Answer Correctly

to convert alternating current into direct current

as a primary power source

to maintain power in a circuit when the primary power source is disconnected

to allow a small amount of current to control a large amount of current


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.