Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances. A line drop is a decrease in voltage between two points on an electrical transmission line due to resistance in the line. A lower current and higher voltage across the line will help compensate for the line drop.

A fuse is a type of low resistance resistor that stops current flow in a circuit in response to a larger than intended electric current flow. Using a fuse with a higher current rating than required by a circuit is less safe as it could potentially allow overcurrent and risk a fire or heat-related equipment damage.

A semiconductor is a material that has a limited ability to conduct electrical current with conductivity between that of an insulator and that of a conductor. Silicon, a cheap and abundant material, is the most used semiconductor material although other materials are used in the electronics components made from semiconductors. The primary advantages of a semiconductor over a conductor is that the conductivity of a semiconductor can be varied under an external electrical field giving engineers precise control over complex circuits and, unlike conductors like metals, a semiconductor's conductivity increases with increased temperatures.

An inductor is coiled wire that stores electric energy in the form of magnetic energy and resists changes in the electric current flowing through it. If current is increasing, the inductor produces a voltage that slows the increase and, if current is decreasing, the magnetic energy in the coil opposes the decrease to keep the current flowing longer. In contrast to capacitors, inductors allow DC to pass easily but resist the flow of AC.

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.