In a parallel circuit, each load occupies a separate parallel path in the circuit and the input voltage is fully applied to each path. Unlike a series circuit where current (I) is the same at all points in the circuit, in a parallel circuit, voltage (V) is the same across each parallel branch of the circuit but current differs in each branch depending on the load (resistance) present.

Lights connected in series form a chain with each light connecting to adjacent lights via one wire. Therefore, if one of the lights burns out and breaks the series, none of the other lights will receive power and they'll go dark. Lights connected in parallel each connect to the positive and negative nodes of the power source and would not go dark if one of their neighbors burnt out.

An amplifier is a device that takes a small input signal and creates a larger output signal. This makes it most similar to a step-up transformer which takes a smaller input voltage and creates a larger output voltage.

Resistors are used to limit voltage and/or current in a circuit and can have a fixed or variable resistance.  Variable resistors (often called potentiometers or rheostats) are used when dynamic control over the voltage/current in a circuit is needed, for example, in a light dimmer or volume control.

Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.