| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 3.13 |
| Score | 0% | 63% |
In an electronic circuit, a thermocouple can be used to:
increase or decrease the temperature of a component in the circuit |
|
keep the circuit at a designated safe temperature |
|
link the temperature of one component in the circuit to that of another component in the circuit |
|
open or close a circuit at a designated temperature |
A thermocouple is a temperature sensor that consists of two wires made from different conductors. The junction of these two wires produces a voltage based on the temperature difference between them and can be used like a switch to open or close the circuit at a designated temperature.
Which of the following allows current to pass easily in one direction and blocks current in the other direction?
capacitor |
|
diode |
|
inductor |
|
resistor |
A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.
This circuit diagram represents a(n):
rectifier |
|
parallel circuit |
|
series circuit |
|
series-parallel circuit |
In a parallel circuit, each load occupies a separate parallel path in the circuit and the input voltage is fully applied to each path. Unlike a series circuit where current (I) is the same at all points in the circuit, in a parallel circuit, voltage (V) is the same across each parallel branch of the circuit but current differs in each branch depending on the load (resistance) present.
Electrical power is measured in:
amperes |
|
watts |
|
volts |
|
coulombs |
Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.
What is the primary difference between a rectifier and an inverter?
a rectifier strips out the AC portion of electricity while an inverter strips out the DC portion |
|
a rectifier converts an AC input to DC while an inverter converts a DC input to AC |
|
a rectifier converts a DC input to AC while an inverter converts an AC input to DC |
|
a rectifier strips out the DC portion of electricity while an inverter strips out the AC portion |
A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.