ASVAB Electronics Information Practice Test 478723 Results

Your Results Global Average
Questions 5 5
Correct 0 3.06
Score 0% 61%

Review

1

In an electronic circuit, a thermocouple can be used to:

42% Answer Correctly

keep the circuit at a designated safe temperature

increase or decrease the temperature of a component in the circuit

open or close a circuit at a designated temperature

link the temperature of one component in the circuit to that of another component in the circuit


Solution

A thermocouple is a temperature sensor that consists of two wires made from different conductors. The junction of these two wires produces a voltage based on the temperature difference between them and can be used like a switch to open or close the circuit at a designated temperature.


2

The conductivity of an element depends on how many electrons occupy which electron shell?

78% Answer Correctly

middle

outer

inner

first


Solution

All electricity is the movement of electrons which are subatomic particles that orbit the nucleus of an atom. Electrons occupy various energy levels called shells and how well an element enables the flow of electrons depends on how many electrons occupy its outer (valence) electron shell.


3

In household electrical wiring, which color of insulation indicates the 'hot' wire?

51% Answer Correctly

green

black

white

red


Solution

In the NM cable used for wiring homes, each cable has three wires inside a sheath with each wire covered in a different color of insulation to indicate its type. The wire with the black insulation is the 'hot' wire, white is the neutral wire, and the ground wire is either covered in green insulation or left bare.


4

The conversion of alternating current (AC) into direct current (DC) is called:

69% Answer Correctly

reactance

inductance

rectification

capacitance


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


5

This circuit diagram represents a(n):

65% Answer Correctly

parallel circuit

series circuit

rectifier

series-parallel circuit


Solution

In a parallel circuit, each load occupies a separate parallel path in the circuit and the input voltage is fully applied to each path. Unlike a series circuit where current (I) is the same at all points in the circuit, in a parallel circuit, voltage (V) is the same across each parallel branch of the circuit but current differs in each branch depending on the load (resistance) present.