ASVAB Electronics Information Practice Test 48120 Results

Your Results Global Average
Questions 5 5
Correct 0 3.36
Score 0% 67%

Review

1 A circuit with a 120-volt power supply is protected by a 10-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
82% Answer Correctly
1200 W
3600 W
1320 W
1080 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 10A circuit breaker would allow is 120V x 10A = 1200 W.

2

The valence shell of n insulator is how full of electrons?

56% Answer Correctly

less than half full

empty

more than half full

half full


Solution

Insulators have valence shells that are more than half full of electrons and, as such, are tightly bound to the nucleus and difficult to move from one atom to another.


3

You would measure the amount of resistance at a certain point in a circuit with a(n):

78% Answer Correctly

potentiometer

ohmmeter

ammeter

voltmeter


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). An ohmmeter is used to measure the amount of resistance at a certain point in a circuit.


4

Capacitors store:

68% Answer Correctly

electricity

resistance

current

capacitance


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


5

In household electrical wiring, which color of insulation indicates the 'hot' wire?

51% Answer Correctly

black

red

white

green


Solution

In the NM cable used for wiring homes, each cable has three wires inside a sheath with each wire covered in a different color of insulation to indicate its type. The wire with the black insulation is the 'hot' wire, white is the neutral wire, and the ground wire is either covered in green insulation or left bare.