ASVAB Electronics Information Practice Test 483132 Results

Your Results Global Average
Questions 5 5
Correct 0 3.25
Score 0% 65%

Review

1

A solid state device has which of the following characteristics?

53% Answer Correctly

made entirely from insulative material

made entirely from conductive material

made from a mix of conductive and insulative material

made entirely from semiconductor material


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


2

Voltage and current are __________ proportional.

66% Answer Correctly

directly

indirectly

inversely

not


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.


3

The conversion of alternating current (AC) into direct current (DC) is called:

69% Answer Correctly

inductance

capacitance

rectification

reactance


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


4

The most common circuit configuration is:

58% Answer Correctly

series-parallel

series

parallel

household


Solution

Circuits are not limited to only series or only parallel configurations. Most circuits contain a mix of series and parallel segments. A good example is a household circuit breaker. Electrical outlets in each section of the house are wired in parallel with the circuit breaker for that section wired in series making it easy to cut off electricity to the parallel parts of the circuit when needed.


5

The watt is a unit of measurement for:

78% Answer Correctly

resistance

energy

power

frequency


Solution

Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.