ASVAB Electronics Information Practice Test 489091 Results

Your Results Global Average
Questions 5 5
Correct 0 3.26
Score 0% 65%

Review

1

Voltage and current are __________ proportional.

66% Answer Correctly

not

indirectly

inversely

directly


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.


2 What's the overall power consumption of a piece of equipment that is rated for 8 amps at 150 volts?
80% Answer Correctly
600 W
1080 W
1200 W
400 W

Solution
Power is measured in watts (W) and 1 watt equals 1 ampere multiplied by 1 volt: P = \( V \times I \). For this problem, the equipment is rated for 8 amps (I) at 150 volts (V) so the equation becomes P = \( 150 \times 8 \) = 1200 W

3

In electrical wiring, which of the following are proportional?

50% Answer Correctly

the length of the wire and the amount of the current

the length of the wire and the amount of the voltage

the diameter of the wire and the amount of the voltage

the diameter of the wire and the amount of the current


Solution

Current flow through a wire increases the temperature of the wire. If too small a wire is used, the wire will heat up causing a loss in conductivity and possibly a fire. The thicker in diameter a wire is, the more current it can carry without overheating.


4

The conversion of alternating current (AC) into direct current (DC) is called:

69% Answer Correctly

rectification

capacitance

inductance

reactance


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


5

What kind of diode allows current to flow in the opposite direction once a certain voltage threshold is reached?

50% Answer Correctly

standard diode

v-type diode

light emitting diode

zener diode


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. A zener diode is a diode which allows current to flow in one direction as normal and will also allow current flow in the reverse direction when the voltage is above a certain value. This value is called the breakdown voltage.