ASVAB Electronics Information Practice Test 490549 Results

Your Results Global Average
Questions 5 5
Correct 0 3.63
Score 0% 73%

Review

1

Which of the following is a difference between a circuit breaker and a fuse?

80% Answer Correctly

all of these

a fuse is cheaper than a circuit breaker

a circuit breaker can be reused

a fuse responds more quickly than a circuit breaker


Solution

Like fuses, circuit breakers stop current flow once it reaches a certain amount. They have the advantage of being reusable (fuses must be replaced when "blown") but respond more slowly to current surges and are more expensive than fuses.


2 A circuit with a 120-volt power supply is protected by a 5-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
82% Answer Correctly
600 W
660 W
608 W
602 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 5A circuit breaker would allow is 120V x 5A = 600 W.

3 How would you connect 6 [12V 5A] batteries to achieve a combined power output of 36V 15A?
66% Answer Correctly
parallel
orthogonal
series-parallel
series

Solution

Connecting the 6 batteries in series multiplies their voltage while keeping their current the same yielding a 72V 5A configuration. Connecting the 6 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 12V 30A configuration. Using a series-parallel connection, 3 batteries can be connected in series and 3 can be connected in parallel resulting in a 36V 15A configuration.


4 Use Ohm's Law to calculate the value of current in this circuit if voltage is 180 volts and resistance is 60 Ω.
80% Answer Correctly
3 A
1 A
11 A
-5 A

Solution

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.

Solved for current, I = \( \frac{V}{R} \) = \( \frac{180}{60} \) = 3 A


5

A solid state device has which of the following characteristics?

53% Answer Correctly

made from a mix of conductive and insulative material

made entirely from conductive material

made entirely from semiconductor material

made entirely from insulative material


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.