ASVAB Electronics Information Practice Test 492356 Results

Your Results Global Average
Questions 5 5
Correct 0 2.87
Score 0% 57%

Review

1

Which of the following is the preferred method for splicing wires?

57% Answer Correctly

screw-on connectors

wire crimps

soldering

wrap in small gauge wire


Solution

Splicing is permanently joining two wires together. Splicing can be done with screw-on connectors or wire crimps but the preferred method for splicing is soldering. Soldering takes the most effort but results in a connection that is electrically and mechanically identical to the original wire.


2

This circuit diagram represents a(n):

69% Answer Correctly

series-parallel circuit

series circuit

parallel circuit

open circuit


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.


3

The sum of the voltage drops across each resistor in a __________ circuit will equal the total voltage applied to the circuit.

54% Answer Correctly

series

parallel

closed

series-parallel


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.


4

A transistor to an electronic circuit is like a _______________ to a house?

68% Answer Correctly

driveway

safe

gate

no trespassing sign


Solution

A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor. A transistor acts as a gate or switch for electronic signals.


5

Which of the following is not a common type of battery?

40% Answer Correctly

power-cycle

wet cell

dry cell

deep-cycle


Solution

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery. The three most common types of batteries are dry cell (used in small devices like TV remotes), wet cell (used for cars), and deep-cycle (storage batteries used primarily for backup and emergency power).