ASVAB Electronics Information Practice Test 497789 Results

Your Results Global Average
Questions 5 5
Correct 0 3.49
Score 0% 70%

Review

1 Use Ohm's Law to calculate the value of voltage in this circuit if resistance is 60 Ω and current is 3.5 amps.
85% Answer Correctly
315 V
420 V
208 V
210 V

Solution

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.

V = \( I \times R \) = \( 3.5 \times 60 \) = 210 V


2

Why is an insulator a poor conductor of electricity?

68% Answer Correctly

an insulator is made of inorganic material

an insulator is made of organic material

an insulator has many free electrons

an insulator has few free electrons


Solution

Insulators have valence shells that are more than half full of electrons and, as such, are tightly bound to the nucleus and difficult to move from one atom to another.


3

Which of the following is not a characteristic of direct current?

47% Answer Correctly

electrons flow in only one consistent direction

cannot easily travel distances without power loss

an example power source is a generator

used to power your cell phone


Solution

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of DC is a battery. In contrast to the constant one-way flow of direct current, alternating current changes direction many times each second. Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances.


4

What type of current flows in only one direction in a circuit?

82% Answer Correctly

alternating

direct

parallel

series


Solution

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery.


5

A capacitor is often used for which of the following purposes?

68% Answer Correctly

to convert alternating current into direct current

as a primary power source

to allow a small amount of current to control a large amount of current

to maintain power in a circuit when the primary power source is disconnected


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.