| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 3.14 |
| Score | 0% | 63% |
In electrical wiring, which of the following are proportional?
the length of the wire and the amount of the voltage |
|
the diameter of the wire and the amount of the current |
|
the diameter of the wire and the amount of the voltage |
|
the length of the wire and the amount of the current |
Current flow through a wire increases the temperature of the wire. If too small a wire is used, the wire will heat up causing a loss in conductivity and possibly a fire. The thicker in diameter a wire is, the more current it can carry without overheating.
Capacitors are charged by what type of current?
direct |
|
high voltage |
|
alternating |
|
low voltage |
Capacitors store voltage and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.
Current is the rate of flow of electrons per unit time and is measured in:
ohms |
|
coulombs |
|
volts |
|
amperes |
Current is the rate of flow of electrons per unit time and is measured in amperes (A). A coulomb (C) is the quantity of electricity conveyed in one second by a current of one ampere.
An engineer who wants to document an electric circuit would create which of the following?
a layout |
|
a schematic |
|
a matrix |
|
a blueprint |
A schematic is the proper name for a drawing of an electric or electronic circuit.
This circuit component symbol represents a(n):
potentiometer |
|
capacitor |
|
diode |
|
fuse |
Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.