ASVAB Electronics Information Practice Test 525062 Results

Your Results Global Average
Questions 5 5
Correct 0 3.33
Score 0% 67%

Review

1

Which of the following is the formula for calculating electrical power?

73% Answer Correctly

P = I2V

P = IV

\(P = {V \over I}\)

\(P = {I \over V}\)


Solution

Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.


2

This circuit diagram represents a(n):

68% Answer Correctly

open circuit

series-parallel circuit

series circuit

parallel circuit


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.


3

An amplifier is most similar in function to which of the following:

65% Answer Correctly

step-down transformer

capacitor

transistor

step-up transformer


Solution

An amplifier is a device that takes a small input signal and creates a larger output signal. This makes it most similar to a step-up transformer which takes a smaller input voltage and creates a larger output voltage.


4

The conversion of alternating current (AC) into direct current (DC) is called:

69% Answer Correctly

rectification

reactance

inductance

capacitance


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


5

What is the potential difference in an electrical circuit a measure of?

57% Answer Correctly

the resistance at a specific location in the circuit

the load at a specific location in the circuit

the voltage at a specific location in the circuit

the current at a specific location in the circuit


Solution

Electrons flow from an area of high concentration to an area of low concentration. A high voltage indicates a high concentration of electrons that creates a greater potential for electron flow than a low voltage. When applied to a load, voltage creates electricity and potential difference is the measure of voltage at a specific location in an electrical circuit.