ASVAB Electronics Information Practice Test 531028 Results

Your Results Global Average
Questions 5 5
Correct 0 3.55
Score 0% 71%

Review

1

One of the lights on your Christmas tree burns out and this causes the rest of the lights connected to that strand to go dark. How are the lights in that strand connected?

73% Answer Correctly

series-parallel

series

perpendicular

parallel


Solution

Lights connected in series form a chain with each light connecting to adjacent lights via one wire. Therefore, if one of the lights burns out and breaks the series, none of the other lights will receive power and they'll go dark. Lights connected in parallel each connect to the positive and negative nodes of the power source and would not go dark if one of their neighbors burnt out.


2

The conversion of alternating current (AC) into direct current (DC) is called:

69% Answer Correctly

rectification

capacitance

inductance

reactance


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


3

Capacitors store:

68% Answer Correctly

resistance

capacitance

current

electricity


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


4

In a series circuit, which of the following is the same across all branches of the circuit?

60% Answer Correctly

conductance

voltage

current

resistance


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.


5 Use Ohm's Law to calculate the value of voltage in this circuit if resistance is 80 Ω and current is 3.5 amps.
85% Answer Correctly
280 V
286 V
140 V
840 V

Solution

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.

V = \( I \times R \) = \( 3.5 \times 80 \) = 280 V