| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 3.25 |
| Score | 0% | 65% |
You would measure the amount of voltage between two points in a circuit with a(n):
voltmeter |
|
reostat |
|
battery |
|
ammeter |
Voltage (V) is the electrical potential difference between two points. A voltmeter is used to measure the voltage between two points in a circuit.
Why is an insulator a poor conductor of electricity?
an insulator is made of inorganic material |
|
an insulator is made of organic material |
|
an insulator has few free electrons |
|
an insulator has many free electrons |
Insulators have valence shells that are more than half full of electrons and, as such, are tightly bound to the nucleus and difficult to move from one atom to another.
What is the potential difference in an electrical circuit a measure of?
the current at a specific location in the circuit |
|
the voltage at a specific location in the circuit |
|
the resistance at a specific location in the circuit |
|
the load at a specific location in the circuit |
Electrons flow from an area of high concentration to an area of low concentration. A high voltage indicates a high concentration of electrons that creates a greater potential for electron flow than a low voltage. When applied to a load, voltage creates electricity and potential difference is the measure of voltage at a specific location in an electrical circuit.
What is the voltage of most household electrical systems in the United States?
110V |
|
60Hz |
|
60V |
|
220V |
Most households use electricity with a voltage of 110V.
The most common circuit configuration is:
series-parallel |
|
parallel |
|
household |
|
series |
Circuits are not limited to only series or only parallel configurations. Most circuits contain a mix of series and parallel segments. A good example is a household circuit breaker. Electrical outlets in each section of the house are wired in parallel with the circuit breaker for that section wired in series making it easy to cut off electricity to the parallel parts of the circuit when needed.