ASVAB Electronics Information Practice Test 561994 Results

Your Results Global Average
Questions 5 5
Correct 0 3.19
Score 0% 64%

Review

1

If an electrical circuit is interrupted, which of the following will result?

61% Answer Correctly

parallel circuit

short circuit

open circuit

closed circuit


Solution

A closed circuit is a complete loop or path that electricity follows. It consists of a source of voltage, a load, and connective conductors. If the circuit is interrupted, if a wire is disconnected or cut for example, it becomes an open circuit and no electricity will flow.


2

Which of the following will increase the magnetic field produced by the electric current in a wire?

67% Answer Correctly

construct the wire from insulative material

wrap the wire around a ceramic core

construct the wire from conductive material

wind the wire into a coil


Solution

A moving electric current produces a magnetic field proportional to the amount of current flow. This magnetic field can be made stronger by winding the wire into a coil and further enhanced if done around an iron containing (ferrous) core.


3

Which of the following is not a terminal on a transistor?

59% Answer Correctly

base

input

emitter

collector


Solution

A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


4

The joule is a unit of measurement for:

67% Answer Correctly

capacitance

resistance

energy

power


Solution

The joule is a unit of measurement for energy.


5

Capacitors are charged by what type of current?

64% Answer Correctly

alternating

low voltage

direct

high voltage


Solution

Capacitors store voltage and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.