ASVAB Electronics Information Practice Test 567096 Results

Your Results Global Average
Questions 5 5
Correct 0 3.29
Score 0% 66%

Review

1

The diameter of a number 12 wire is __________ the diameter of a number 6 wire?

52% Answer Correctly

more than

triple

less than

double


Solution

The larger the number the smaller the diameter of the wire. So, the diameter of a number 12 wire is less than the diameter of a number 6 wire.


2 How would you connect 6 [15V 25A] batteries to achieve a combined power output of 45V 75A?
66% Answer Correctly
series-parallel
orthogonal
series
parallel

Solution

Connecting the 6 batteries in series multiplies their voltage while keeping their current the same yielding a 90V 25A configuration. Connecting the 6 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 15V 150A configuration. Using a series-parallel connection, 3 batteries can be connected in series and 3 can be connected in parallel resulting in a 45V 75A configuration.


3

The ohm is a unit of measurement for:

81% Answer Correctly

power

resistance

energy

capacitance


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


4

Resistance is measured in:

86% Answer Correctly

ohms

volts

amperes

coulombs


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


5

In an electronic circuit, a thermocouple can be used to:

42% Answer Correctly

keep the circuit at a designated safe temperature

open or close a circuit at a designated temperature

link the temperature of one component in the circuit to that of another component in the circuit

increase or decrease the temperature of a component in the circuit


Solution

A thermocouple is a temperature sensor that consists of two wires made from different conductors. The junction of these two wires produces a voltage based on the temperature difference between them and can be used like a switch to open or close the circuit at a designated temperature.