ASVAB Electronics Information Practice Test 583302 Results

Your Results Global Average
Questions 5 5
Correct 0 3.58
Score 0% 72%

Review

1

Resistance and current are __________ proportional.

68% Answer Correctly

exponentially

directly

inversely

not


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


2

The farad is a unit of measurement for:

63% Answer Correctly

energy

capacitance

power

inductance


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


3

Which of the following will help to prevent a short circuit?

74% Answer Correctly

diode

resistor

transistor

fuse


Solution

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.


4 Use Ohm's Law to calculate the value of voltage in this circuit if resistance is 50 Ω and current is 0.5 amps.
85% Answer Correctly
25 V
75 V
50 V
12.5 V

Solution

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.

V = \( I \times R \) = \( 0.5 \times 50 \) = 25 V


5

A capacitor is often used for which of the following purposes?

68% Answer Correctly

to convert alternating current into direct current

to maintain power in a circuit when the primary power source is disconnected

as a primary power source

to allow a small amount of current to control a large amount of current


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.