ASVAB Electronics Information Practice Test 61882 Results

Your Results Global Average
Questions 5 5
Correct 0 3.66
Score 0% 73%

Review

1

Which of these materials is not a good conductor of electricity?

79% Answer Correctly

copper

air

gold

tin


Solution

All conductors have resistance and the amount of resistance varies with the element. In general, metals make the best conductors of electricity and non-metals make the worst conductors of electricity.


2

The sum of the voltage drops across each resistor in a __________ circuit will equal the total voltage applied to the circuit.

54% Answer Correctly

parallel

series

closed

series-parallel


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.


3

You would measure the amount of voltage between two points in a circuit with a(n):

82% Answer Correctly

ammeter

reostat

battery

voltmeter


Solution

Voltage (V) is the electrical potential difference between two points. A voltmeter is used to measure the voltage between two points in a circuit.


4

Using a fuse with a current rating higher than that required by a circuit:

70% Answer Correctly

makes the circuit less safe

is required

makes no difference

is recommended


Solution

A fuse is a type of low resistance resistor that stops current flow in a circuit in response to a larger than intended electric current flow. Using a fuse with a higher current rating than required by a circuit is less safe as it could potentially allow overcurrent and risk a fire or heat-related equipment damage.


5

The volt is a unit of measurement for:

79% Answer Correctly

capacitance

power

voltage

current


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.