Connecting the 8 batteries in series multiplies their voltage while keeping their current the same yielding a 96V 15A configuration. Connecting the 8 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 12V 120A configuration. Using a series-parallel connection, 4 batteries can be connected in series and 4 can be connected in parallel resulting in a 48V 60A configuration.

You can multiply the voltage or the current supplied by individual batteries by connecting them together either in series or in parallel. The characteristics of batteries connected in series are that total voltage equals the sum of the individual battery voltages, total current equals the average of the individual battery currents, the positive terminal of one battery is connected to the negative terminal of the next, and one connection is made between each adjacent battery.

All conductors have resistance and the amount of resistance varies with the element. In general, metals make the best conductors of electricity and non-metals make the worst conductors of electricity.

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.