Lights connected in series form a chain with each light connecting to adjacent lights via one wire. Therefore, if one of the lights burns out and breaks the series, none of the other lights will receive power and they'll go dark. Lights connected in parallel each connect to the positive and negative nodes of the power source and would not go dark if one of their neighbors burnt out.

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.

The hertz is a unit of measurement for frequency.

A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor. A transistor acts as a gate or switch for electronic signals.