ASVAB Electronics Information Practice Test 664615 Results

Your Results Global Average
Questions 5 5
Correct 0 3.35
Score 0% 67%

Review

1

Which of the following is the preferred method for splicing wires?

57% Answer Correctly

wrap in small gauge wire

screw-on connectors

soldering

wire crimps


Solution

Splicing is permanently joining two wires together. Splicing can be done with screw-on connectors or wire crimps but the preferred method for splicing is soldering. Soldering takes the most effort but results in a connection that is electrically and mechanically identical to the original wire.


2

This circuit component symbol represents a(n):

60% Answer Correctly

inductor

resistor

capacitor

transformer


Solution

An inductor is coiled wire that stores electric energy in the form of magnetic energy and resists changes in the electric current flowing through it. If current is increasing, the inductor produces a voltage that slows the increase and, if current is decreasing, the magnetic energy in the coil opposes the decrease to keep the current flowing longer. In contrast to capacitors, inductors allow DC to pass easily but resist the flow of AC.


3

Electrical power is measured in:

74% Answer Correctly

amperes

watts

volts

coulombs


Solution

Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.


4

Using a fuse with a current rating higher than that required by a circuit:

70% Answer Correctly

makes the circuit less safe

makes no difference

is recommended

is required


Solution

A fuse is a type of low resistance resistor that stops current flow in a circuit in response to a larger than intended electric current flow. Using a fuse with a higher current rating than required by a circuit is less safe as it could potentially allow overcurrent and risk a fire or heat-related equipment damage.


5

Which of the following statements about electrical resistance is true?

74% Answer Correctly

electrically conductive materials have no resistive properties

the more resistive the conductor is the faster electron flow will be

the more resistive the conductor is the slower electron flow will be

the less resistive the conductor is the slower electron flow will be


Solution

Resistance is opposition to the flow of current. As resistance increases, current decreases as resistance and current are inversely proportional.