ASVAB Electronics Information Practice Test 67146 Results

Your Results Global Average
Questions 5 5
Correct 0 3.38
Score 0% 68%

Review

1

The volt is a unit of measurement for:

79% Answer Correctly

capacitance

voltage

current

power


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.


2

What is the primary difference between a rectifier and an inverter?

61% Answer Correctly

a rectifier converts a DC input to AC while an inverter converts an AC input to DC

a rectifier strips out the DC portion of electricity while an inverter strips out the AC portion

a rectifier strips out the AC portion of electricity while an inverter strips out the DC portion

a rectifier converts an AC input to DC while an inverter converts a DC input to AC


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


3

Which of the following is the formula for calculating electrical power?

73% Answer Correctly

\(P = {I \over V}\)

P = IV

\(P = {V \over I}\)

P = I2V


Solution

Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.


4

Which of the following is not a characteristic of a step-up transformer?

54% Answer Correctly

the secondary voltage is higher than the primary voltage

the primary voltage is higher than the secondary voltage

increases voltage

has more turns in the secondary winding than in the primary winding


Solution

As their names indicate, a step-up transformer is used to step up or increase voltage and a step-down transformer is used to step down or decrease voltage. In a step-up transformer, the secondary voltage is higher than the primary voltage and it has more turns in the secondary winding than in the primary winding.


5

This circuit diagram represents a(n):

69% Answer Correctly

open circuit

series circuit

parallel circuit

series-parallel circuit


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.