ASVAB Electronics Information Practice Test 691923 Results

Your Results Global Average
Questions 5 5
Correct 0 3.11
Score 0% 62%

Review

1

Which of the following will help to prevent a short circuit?

74% Answer Correctly

resistor

fuse

diode

transistor


Solution

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.


2

In electrical wiring, which of the following are proportional?

50% Answer Correctly

the diameter of the wire and the amount of the voltage

the length of the wire and the amount of the voltage

the length of the wire and the amount of the current

the diameter of the wire and the amount of the current


Solution

Current flow through a wire increases the temperature of the wire. If too small a wire is used, the wire will heat up causing a loss in conductivity and possibly a fire. The thicker in diameter a wire is, the more current it can carry without overheating.


3 Suppose you have 4 [6V 5A] batteries that you can connect together in series, in parallel, or in series-parallel. Which of the following voltage and ampere combinations cannot be attained using these 4 batteries?
46% Answer Correctly
24V 5A
24V 20A
12V 10A
6V 20A

Solution

Connecting the 4 batteries in series multiplies their voltage while keeping their current the same yielding a 24V 5A configuration. Connecting the 4 batteries in parallel multiplies their current while keeping their voltage the same yielding a 6V 20A configuration. Using a series-parallel connection, 2 batteries can be connected in series and 2 can be connected in parallel resulting in a 12V 10A configuration.


4

Which of the following is not a purpose of a resistor in an electrical circuit?

70% Answer Correctly

control the voltage in the circuit

multiply the current in the circuit

moderate the heat in the circuit

limit the current in the circuit


Solution

Resistors can be chosen in a wide variety of values to control the voltage in a circuit, limit the current, or moderate the heat produced by the components in the circuit.


5

Which of the following is the formula for calculating electrical power?

73% Answer Correctly

P = I2V

\(P = {V \over I}\)

P = IV

\(P = {I \over V}\)


Solution

Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.