ASVAB Electronics Information Practice Test 695713 Results

Your Results Global Average
Questions 5 5
Correct 0 3.40
Score 0% 68%

Review

1

The volt is a unit of measurement for:

79% Answer Correctly

current

voltage

power

capacitance


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.


2

From what energy do photovoltaic cells produce electrical energy?

68% Answer Correctly

magnetic

sun

chemical

nuclear


Solution

A photovoltaic cell (also known as a solar cell) converts energy from the sun into electrical energy.


3

A __________ electric current produces a magnetic field proportional to the amount of current flow.

61% Answer Correctly

stationary

moving

high voltage

low voltage


Solution

A moving electric current produces a magnetic field proportional to the amount of current flow. This magnetic field can be made stronger by winding the wire into a coil and further enhanced if done around an iron containing (ferrous) core.


4

An inductor __________ changes in the electric current flowing through it.

61% Answer Correctly

doubles

enhances

resists

eliminates


Solution

An inductor is coiled wire that stores electric energy in the form of magnetic energy and resists changes in the electric current flowing through it. If current is increasing, the inductor produces a voltage that slows the increase and, if current is decreasing, the magnetic energy in the coil opposes the decrease to keep the current flowing longer. In contrast to capacitors, inductors allow DC to pass easily but resist the flow of AC.


5

This circuit component symbol represents a(n):

70% Answer Correctly

resistor

diode

capacitor

fuse


Solution

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.