Connecting the 8 batteries in series multiplies their voltage while keeping their current the same yielding a 96V 15A configuration. Connecting the 8 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 12V 120A configuration. Using a series-parallel connection, 4 batteries can be connected in series and 4 can be connected in parallel resulting in a 48V 60A configuration.

A semiconductor is a material that has a limited ability to conduct electrical current with conductivity between that of an insulator and that of a conductor. Silicon, a cheap and abundant material, is the most used semiconductor material although other materials are used in the electronics components made from semiconductors. The primary advantages of a semiconductor over a conductor is that the conductivity of a semiconductor can be varied under an external electrical field giving engineers precise control over complex circuits and, unlike conductors like metals, a semiconductor's conductivity increases with increased temperatures.

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.

In the NM cable used for wiring homes, each cable has three wires inside a sheath with each wire covered in a different color of insulation to indicate its type. The wire with the black insulation is the 'hot' wire, white is the neutral wire, and the ground wire is either covered in green insulation or left bare.

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.