Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery. The three most common types of batteries are dry cell (used in small devices like TV remotes), wet cell (used for cars), and deep-cycle (storage batteries used primarily for backup and emergency power).

The purpose of a capacitor is to retain electric charge and it will do so even after its input voltage is removed. After the input voltage is removed, the capacitor will slowly discharge but, depending on the size and characteristics of the capacitor, discharging could take from a few minutes to a few years. So, it's never safe to touch a capacitor with your hands and you should make sure to discharge any capacitors in a circuit before working on it using an appropriately high-wattage resistor or a capacitor discharge tool.

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.

In the NM cable used for wiring homes, each cable has three wires inside a sheath with each wire covered in a different color of insulation to indicate its type. The wire with the black insulation is the 'hot' wire, white is the neutral wire, and the ground wire is either covered in green insulation or left bare.

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.