ASVAB Electronics Information Practice Test 726963 Results

Your Results Global Average
Questions 5 5
Correct 0 3.59
Score 0% 72%

Review

1

Current is the rate of flow of electrons per unit time and is measured in:

69% Answer Correctly

amperes

volts

ohms

coulombs


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). A coulomb (C) is the quantity of electricity conveyed in one second by a current of one ampere.


2

From what energy do photovoltaic cells produce electrical energy?

68% Answer Correctly

chemical

nuclear

magnetic

sun


Solution

A photovoltaic cell (also known as a solar cell) converts energy from the sun into electrical energy.


3

What is the primary difference between a rectifier and an inverter?

61% Answer Correctly

a rectifier strips out the DC portion of electricity while an inverter strips out the AC portion

a rectifier strips out the AC portion of electricity while an inverter strips out the DC portion

a rectifier converts a DC input to AC while an inverter converts an AC input to DC

a rectifier converts an AC input to DC while an inverter converts a DC input to AC


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


4

What type of current flows in only one direction in a circuit?

82% Answer Correctly

series

alternating

parallel

direct


Solution

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery.


5

The volt is a unit of measurement for:

79% Answer Correctly

voltage

capacitance

power

current


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.