Splicing is permanently joining two wires together. Splicing can be done with screw-on connectors or wire crimps but the preferred method for splicing is soldering. Soldering takes the most effort but results in a connection that is electrically and mechanically identical to the original wire.

In a parallel circuit, each load occupies a separate parallel path in the circuit and the input voltage is fully applied to each path. Unlike a series circuit where current (I) is the same at all points in the circuit, in a parallel circuit, voltage (V) is the same across each parallel branch of the circuit but current differs in each branch depending on the load (resistance) present.

Resistors can be chosen in a wide variety of values to control the voltage in a circuit, limit the current, or moderate the heat produced by the components in the circuit.

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.

V = \( I \times R \) = \( 10 \times 50 \) = 500 V

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.