Resistors are used to limit voltage and/or current in a circuit and can have a fixed or variable resistance.  Variable resistors (often called potentiometers or rheostats) are used when dynamic control over the voltage/current in a circuit is needed, for example, in a light dimmer or volume control.

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.

An amplifier is a device that takes a small input signal and creates a larger output signal. This makes it most similar to a step-up transformer which takes a smaller input voltage and creates a larger output voltage.

Inductance is a property of an AC circuit (or a component in an AC circuit) that quantifies resistance to changes in current. The current in an AC circuit is continuously changing and inductive reactance (the opposition to change) depends both on the inductance of the circuit or component and the rate at which the current is changing.

You can multiply the voltage or the current supplied by individual batteries by connecting them together either in series or in parallel. The characteristics of batteries connected in parallel are that total voltage equals the average of the individual battery voltages, total current equals the sum of the individual battery currents, the positive terminal of one battery is connected to the positive terminal of the next, the negative terminal of one battery is connected to the negative terminal of the next, and two connections are made between each adjacent battery.