ASVAB Electronics Information Practice Test 734298 Results

Your Results Global Average
Questions 5 5
Correct 0 3.44
Score 0% 69%

Review

1 A circuit with a 120-volt power supply is protected by a 5-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
85% Answer Correctly
600 W
300 W
601.5 W
1800 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 5A circuit breaker would allow is 120V x 5A = 600 W.

2

Current is the rate of flow of electrons per unit time and is measured in:

68% Answer Correctly

volts

coulombs

amperes

ohms


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). A coulomb (C) is the quantity of electricity conveyed in one second by a current of one ampere.


3

The electrical potential difference between two points is called:

60% Answer Correctly

resistance

current

conductance

voltage


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.


4

If an electrical circuit is interrupted, which of the following will result?

61% Answer Correctly

closed circuit

open circuit

parallel circuit

short circuit


Solution

A closed circuit is a complete loop or path that electricity follows. It consists of a source of voltage, a load, and connective conductors. If the circuit is interrupted, if a wire is disconnected or cut for example, it becomes an open circuit and no electricity will flow.


5

Resistance is opposition to which of the following?

70% Answer Correctly

voltage

conductance

current

impedance


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.