ASVAB Electronics Information Practice Test 737204 Results

Your Results Global Average
Questions 5 5
Correct 0 3.10
Score 0% 62%

Review

1

Which of the following will increase the magnetic field produced by the electric current in a wire?

68% Answer Correctly

wrap the wire around a ceramic core

construct the wire from conductive material

construct the wire from insulative material

wind the wire into a coil


Solution

A moving electric current produces a magnetic field proportional to the amount of current flow. This magnetic field can be made stronger by winding the wire into a coil and further enhanced if done around an iron containing (ferrous) core.


2

A transformer utilizes an inductor to increase or decrease what in a circuit?

61% Answer Correctly

resistance

voltage

load

current


Solution

A transformer utilizes an inductor to increase or decrease the voltage in a circuit. AC flowing in a coil wrapped around an iron core magnetizes the core causing it to produce a magnetic field. This magnetic field generates a voltage in a nearby coil of wire and, depending on the number of turns in the wire of the primary (source) and secondary coils and their proximity, voltage is induced in the secondary coil.


3

This circuit diagram represents a(n):

65% Answer Correctly

parallel circuit

series circuit

series-parallel circuit

rectifier


Solution

In a parallel circuit, each load occupies a separate parallel path in the circuit and the input voltage is fully applied to each path. Unlike a series circuit where current (I) is the same at all points in the circuit, in a parallel circuit, voltage (V) is the same across each parallel branch of the circuit but current differs in each branch depending on the load (resistance) present.


4

Which of the following is the formula for calculating electrical power?

73% Answer Correctly

P = I2V

\(P = {I \over V}\)

P = IV

\(P = {V \over I}\)


Solution

Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.


5

Which of the following is not true about a line drop?

43% Answer Correctly

it is caused by resistance

it is addressed by raising voltage and lowering current across the transmission line

it is a decrease in voltage between two points on a line

it is addressed by raising current and lowering voltage across the ransmission line


Solution

Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances. A line drop is a decrease in voltage between two points on an electrical transmission line due to resistance in the line. A lower current and higher voltage across the line will help compensate for the line drop.