ASVAB Electronics Information Practice Test 741292 Results

Your Results Global Average
Questions 5 5
Correct 0 2.88
Score 0% 58%

Review

1

If an electrical circuit is interrupted, which of the following will result?

61% Answer Correctly

parallel circuit

short circuit

open circuit

closed circuit


Solution

A closed circuit is a complete loop or path that electricity follows. It consists of a source of voltage, a load, and connective conductors. If the circuit is interrupted, if a wire is disconnected or cut for example, it becomes an open circuit and no electricity will flow.


2

General current flow in a transistor is from __________ to __________.

51% Answer Correctly

collector, emitter

base, emitter

collector, base

base, collector


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


3

You would measure the amount of resistance at a certain point in a circuit with a(n):

78% Answer Correctly

ammeter

ohmmeter

potentiometer

voltmeter


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). An ohmmeter is used to measure the amount of resistance at a certain point in a circuit.


4

Inductance is a factor in which of the following?

44% Answer Correctly

a DC circuit

an AC circuit

determining energy stored by a capacitor

batteries connected in serial


Solution

Inductance is a property of an AC circuit (or a component in an AC circuit) that quantifies resistance to changes in current. The current in an AC circuit is continuously changing and inductive reactance (the opposition to change) depends both on the inductance of the circuit or component and the rate at which the current is changing.


5

A solid state device has which of the following characteristics?

53% Answer Correctly

made entirely from conductive material

made entirely from semiconductor material

made entirely from insulative material

made from a mix of conductive and insulative material


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.