| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 3.39 |
| Score | 0% | 68% |
Which of the following is not a terminal on a transistor?
emitter |
|
base |
|
collector |
|
input |
A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.
Resistance is opposition to which of the following?
voltage |
|
current |
|
conductance |
|
impedance |
Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.
This circuit diagram represents a(n):
open circuit |
|
series-parallel circuit |
|
series circuit |
|
parallel circuit |
A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.
| 3.33 V | |
| 20 V | |
| 10 V | |
| 12 V |
Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.
V = \( I \times R \) = \( 0.5 \times 20 \) = 10 V
This circuit component symbol represents a(n):
AC source |
|
transformer |
|
DC source |
|
capacitor |
Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery.