ASVAB Electronics Information Practice Test 747414 Results

Your Results Global Average
Questions 5 5
Correct 0 3.14
Score 0% 63%

Review

1

Which of the following is not a common type of battery?

40% Answer Correctly

wet cell

deep-cycle

dry cell

power-cycle


Solution

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery. The three most common types of batteries are dry cell (used in small devices like TV remotes), wet cell (used for cars), and deep-cycle (storage batteries used primarily for backup and emergency power).


2

The formula specifying Ohm's law is which of the following?

76% Answer Correctly

V = IR

\(V = {I \over R}\)

\(V = {R \over I}\)

V = I2R


Solution

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.


3

Resistance and current are __________ proportional.

68% Answer Correctly

directly

not

exponentially

inversely


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


4

The valence shell of n insulator is how full of electrons?

56% Answer Correctly

less than half full

more than half full

empty

half full


Solution

Insulators have valence shells that are more than half full of electrons and, as such, are tightly bound to the nucleus and difficult to move from one atom to another.


5

One of the lights on your Christmas tree burns out and this causes the rest of the lights connected to that strand to go dark. How are the lights in that strand connected?

73% Answer Correctly

parallel

perpendicular

series

series-parallel


Solution

Lights connected in series form a chain with each light connecting to adjacent lights via one wire. Therefore, if one of the lights burns out and breaks the series, none of the other lights will receive power and they'll go dark. Lights connected in parallel each connect to the positive and negative nodes of the power source and would not go dark if one of their neighbors burnt out.