| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 3.26 |
| Score | 0% | 65% |
Which of the following is not an advantage of semiconductors over conductors?
a semiconductor conducts current better than a conductor |
|
a semiconductor's conductivity can be varied under an external electrical field |
|
a semiconductor exhibits increased conductivity with increased temperatures |
|
materials to produce semiconductors are cheap and abundant |
A semiconductor is a material that has a limited ability to conduct electrical current with conductivity between that of an insulator and that of a conductor. Silicon, a cheap and abundant material, is the most used semiconductor material although other materials are used in the electronics components made from semiconductors. The primary advantages of a semiconductor over a conductor is that the conductivity of a semiconductor can be varied under an external electrical field giving engineers precise control over complex circuits and, unlike conductors like metals, a semiconductor's conductivity increases with increased temperatures.
Resistance is measured in:
coulombs |
|
ohms |
|
amperes |
|
volts |
Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.
The conversion of alternating current (AC) into direct current (DC) is called:
inductance |
|
reactance |
|
rectification |
|
capacitance |
A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.
This circuit diagram represents a(n):
series-parallel circuit |
|
rectifier |
|
series circuit |
|
parallel circuit |
In a parallel circuit, each load occupies a separate parallel path in the circuit and the input voltage is fully applied to each path. Unlike a series circuit where current (I) is the same at all points in the circuit, in a parallel circuit, voltage (V) is the same across each parallel branch of the circuit but current differs in each branch depending on the load (resistance) present.
A transistor works by allowing a small amount of current to control general current flow. Where is the small amount of current applied?
base |
|
emitter |
|
collector |
|
input |
The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.