ASVAB Electronics Information Practice Test 764089 Results

Your Results Global Average
Questions 5 5
Correct 0 3.25
Score 0% 65%

Review

1

Which of the following is not a characteristic of a step-up transformer?

54% Answer Correctly

the secondary voltage is higher than the primary voltage

increases voltage

the primary voltage is higher than the secondary voltage

has more turns in the secondary winding than in the primary winding


Solution

As their names indicate, a step-up transformer is used to step up or increase voltage and a step-down transformer is used to step down or decrease voltage. In a step-up transformer, the secondary voltage is higher than the primary voltage and it has more turns in the secondary winding than in the primary winding.


2

Inductance is a factor in which of the following?

44% Answer Correctly

an AC circuit

determining energy stored by a capacitor

batteries connected in serial

a DC circuit


Solution

Inductance is a property of an AC circuit (or a component in an AC circuit) that quantifies resistance to changes in current. The current in an AC circuit is continuously changing and inductive reactance (the opposition to change) depends both on the inductance of the circuit or component and the rate at which the current is changing.


3 What's the overall power consumption of a piece of equipment that is rated for 8 amps at 50 volts?
80% Answer Correctly
200 W
440 W
402 W
400 W

Solution
Power is measured in watts (W) and 1 watt equals 1 ampere multiplied by 1 volt: P = \( V \times I \). For this problem, the equipment is rated for 8 amps (I) at 50 volts (V) so the equation becomes P = \( 50 \times 8 \) = 400 W

4

You would measure the amount of current through a circuit with a(n):

69% Answer Correctly

battery

ammeter

potentiometer

voltmeter


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). An ammeter is used to measure the electric current in a circuit.


5

Voltage and current are __________ proportional.

66% Answer Correctly

not

inversely

indirectly

directly


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.