ASVAB Electronics Information Practice Test 774583 Results

Your Results Global Average
Questions 5 5
Correct 0 3.27
Score 0% 65%

Review

1

The joule is a unit of measurement for:

67% Answer Correctly

energy

capacitance

resistance

power


Solution

The joule is a unit of measurement for energy.


2

The sum of the voltage drops across each resistor in a __________ circuit will equal the total voltage applied to the circuit.

54% Answer Correctly

series

closed

series-parallel

parallel


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.


3

Resistance and current are __________ proportional.

68% Answer Correctly

exponentially

directly

not

inversely


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


4

Resistance is opposition to which of the following?

70% Answer Correctly

voltage

impedance

current

conductance


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


5

Capacitors store:

68% Answer Correctly

current

electricity

capacitance

resistance


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.