Your Results | Global Average | |
---|---|---|
Questions | 5 | 5 |
Correct | 0 | 2.75 |
Score | 0% | 55% |
Which of the following is not a characteristic of a step-up transformer?
increases voltage |
|
has more turns in the secondary winding than in the primary winding |
|
the primary voltage is higher than the secondary voltage |
|
the secondary voltage is higher than the primary voltage |
As their names indicate, a step-up transformer is used to step up or increase voltage and a step-down transformer is used to step down or decrease voltage. In a step-up transformer, the secondary voltage is higher than the primary voltage and it has more turns in the secondary winding than in the primary winding.
Inductance is a factor in which of the following?
determining energy stored by a capacitor |
|
an AC circuit |
|
batteries connected in serial |
|
a DC circuit |
Inductance is a property of an AC circuit (or a component in an AC circuit) that quantifies resistance to changes in current. The current in an AC circuit is continuously changing and inductive reactance (the opposition to change) depends both on the inductance of the circuit or component and the rate at which the current is changing.
Electromotive force is another name for:
power |
|
current |
|
voltage |
|
energy |
Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.
In a series circuit, which of the following is the same across all branches of the circuit?
conductance |
|
current |
|
voltage |
|
resistance |
A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.
This circuit component symbol represents a(n):
potentiometer |
|
fuse |
|
diode |
|
capacitor |
Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.