| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 3.13 |
| Score | 0% | 63% |
| series | |
| orthogonal | |
| series-parallel | |
| parallel |
Connecting the 8 batteries in series multiplies their voltage while keeping their current the same yielding a 72V 25A configuration. Connecting the 8 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 9V 200A configuration. Using a series-parallel connection, 4 batteries can be connected in series and 4 can be connected in parallel resulting in a 36V 100A configuration.
The watt is a unit of measurement for:
resistance |
|
energy |
|
power |
|
frequency |
Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.
The voltage output of a transformer primarily depends on which of the following?
the diameter of the wire in the coils |
|
the conductor used for the wire in the coils |
|
the diameter of the coils |
|
the number of turns in the wire of the coils |
A transformer utilizes an inductor to increase or decrease the voltage in a circuit. AC flowing in a coil wrapped around an iron core magnetizes the core causing it to produce a magnetic field. This magnetic field generates a voltage in a nearby coil of wire and, depending on the number of turns in the wire of the primary (source) and secondary coils and their proximity, voltage is induced in the secondary coil.
This circuit component symbol represents a(n):
diode |
|
inductor |
|
capacitor |
|
transistor |
A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.
Which of the following is not a characteristic of a step-up transformer?
increases voltage |
|
has more turns in the secondary winding than in the primary winding |
|
the primary voltage is higher than the secondary voltage |
|
the secondary voltage is higher than the primary voltage |
As their names indicate, a step-up transformer is used to step up or increase voltage and a step-down transformer is used to step down or decrease voltage. In a step-up transformer, the secondary voltage is higher than the primary voltage and it has more turns in the secondary winding than in the primary winding.