ASVAB Electronics Information Practice Test 806828 Results

Your Results Global Average
Questions 5 5
Correct 0 3.20
Score 0% 64%

Review

1

Which of the following allows current to pass easily in one direction and blocks current in the other direction?

69% Answer Correctly

resistor

diode

inductor

capacitor


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


2

Using a fuse with a current rating higher than that required by a circuit:

70% Answer Correctly

is required

makes no difference

makes the circuit less safe

is recommended


Solution

A fuse is a type of low resistance resistor that stops current flow in a circuit in response to a larger than intended electric current flow. Using a fuse with a higher current rating than required by a circuit is less safe as it could potentially allow overcurrent and risk a fire or heat-related equipment damage.


3

Which of the following is a characteristic of batteries connected in series?

61% Answer Correctly

the positive terminal of one battery is connected to the positive terminal of the next

two connections are made between each adjacent battery

total voltage equals the average of the individual battery voltages

total voltage equals the sum of the individual battery voltages


Solution

You can multiply the voltage or the current supplied by individual batteries by connecting them together either in series or in parallel. The characteristics of batteries connected in series are that total voltage equals the sum of the individual battery voltages, total current equals the average of the individual battery currents, the positive terminal of one battery is connected to the negative terminal of the next, and one connection is made between each adjacent battery.


4

You would measure the amount of current through a circuit with a(n):

68% Answer Correctly

voltmeter

ammeter

potentiometer

battery


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). An ammeter is used to measure the electric current in a circuit.


5

Electromotive force is another name for:

53% Answer Correctly

voltage

power

current

energy


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.