Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.

Resistors can be chosen in a wide variety of values to control the voltage in a circuit, limit the current, or moderate the heat produced by the components in the circuit.

A diode allows current to pass easily in one direction and blocks current in the other direction. A zener diode is a diode which allows current to flow in one direction as normal and will also allow current flow in the reverse direction when the voltage is above a certain value. This value is called the breakdown voltage.

Electrons flow from an area of high concentration to an area of low concentration. A high voltage indicates a high concentration of electrons that creates a greater potential for electron flow than a low voltage. When applied to a load, voltage creates electricity and potential difference is the measure of voltage at a specific location in an electrical circuit.

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.