ASVAB Electronics Information Practice Test 838089 Results

Your Results Global Average
Questions 5 5
Correct 0 3.36
Score 0% 67%

Review

1

Which of the following is not true about a line drop?

43% Answer Correctly

it is addressed by raising current and lowering voltage across the ransmission line

it is caused by resistance

it is addressed by raising voltage and lowering current across the transmission line

it is a decrease in voltage between two points on a line


Solution

Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances. A line drop is a decrease in voltage between two points on an electrical transmission line due to resistance in the line. A lower current and higher voltage across the line will help compensate for the line drop.


2

Which of the following is a difference between a circuit breaker and a fuse?

80% Answer Correctly

a fuse is cheaper than a circuit breaker

all of these

a fuse responds more quickly than a circuit breaker

a circuit breaker can be reused


Solution

Like fuses, circuit breakers stop current flow once it reaches a certain amount. They have the advantage of being reusable (fuses must be replaced when "blown") but respond more slowly to current surges and are more expensive than fuses.


3

Which of the following is not a terminal on a transistor?

59% Answer Correctly

emitter

collector

base

input


Solution

A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


4

The volt is a unit of measurement for:

79% Answer Correctly

capacitance

power

current

voltage


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.


5

Which of the following will help to prevent a short circuit?

74% Answer Correctly

transistor

fuse

diode

resistor


Solution

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.