ASVAB Electronics Information Practice Test 857836 Results

Your Results Global Average
Questions 5 5
Correct 0 3.09
Score 0% 62%

Review

1

The electrical potential difference between two points is called:

60% Answer Correctly

current

conductance

resistance

voltage


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.


2

Capacitors are charged by what type of current?

64% Answer Correctly

direct

alternating

high voltage

low voltage


Solution

Capacitors store voltage and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


3

You would measure the amount of current through a circuit with a(n):

68% Answer Correctly

potentiometer

battery

voltmeter

ammeter


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). An ammeter is used to measure the electric current in a circuit.


4

Which of the following is not a characteristic of a step-up transformer?

54% Answer Correctly

has more turns in the secondary winding than in the primary winding

the secondary voltage is higher than the primary voltage

increases voltage

the primary voltage is higher than the secondary voltage


Solution

As their names indicate, a step-up transformer is used to step up or increase voltage and a step-down transformer is used to step down or decrease voltage. In a step-up transformer, the secondary voltage is higher than the primary voltage and it has more turns in the secondary winding than in the primary winding.


5

The farad is a unit of measurement for:

63% Answer Correctly

energy

capacitance

power

inductance


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.